GENERAL PAINT & CHEMICAL CO. -- ALUMINUM -- 8010-00F009156
===================== Product Identification ===================== Product ID:ALUMINUM MSDS Date:01/24/1985 FSC:8010 NIIN:00F009156 === Responsible Party === Company Name:GENERAL PAINT & CHEMICAL CO. Address:201 JANDUS ROAD City:CARY State:IL ZIP:60013 Info Phone Num:(312) 639-5383 Emergency Phone Num:(312) 639-5383 CAGE:GENEA === Contractor Identification === Company Name:GENERAL PAINT & CHEMICAL Address:201 JANDUS ROAD City:CARY State:IL ZIP:60013 Phone:(312) 639-5383 CAGE:GENEA ============= Composition/Information on Ingredients ============= Ingred Name:MEDIUM ALIPHATIC NAPHTHA (AROMATIC 100) CAS:64742-88-7 Fraction by Wt: 30-45% Other REC Limits:100 PPM OSHA PEL:500 PPM ACGIH TLV:100 PPM ===================== Hazards Identification ===================== Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO Health Hazards Acute and Chronic:EYE: SEVERE IRRITATION. SKIN: DRYING. INHALATION: HEADACHE, DIZZINESS & NAUSEA. Explanation of Carcinogenicity:NONE Effects of Overexposure:EYE: SEVERE IRRITATION. SKIN: DRYING. INHALATION: HEADACHE, DIZZINESS & NAUSEA. ======================= First Aid Measures ======================= First Aid:EYES/SKIN: WASH W/FRESH WARM WATER & SOAP. INHALATION: REMOVE TO FRESH AIR. APPLY ARTIFICIAL RESPIRATION IF NECESSARY. GET MEDICAL ATTENTION. INGESTION: DON'T INDUCE VOMITING. KEEP PERSON WARM & QUIET . GET MEDICAL ATTENTION. ===================== Fire Fighting Measures ===================== Flash Point:105F Lower Limits:0.9% Extinguishing Media:FOAM, CO2, DRY CHEMICAL, WATER FOG Fire Fighting Procedures:TREAT AS A VOLATILE LIQUID FIRE. WATER SPRAY MAY BE INEFFECTIVE. IF WATER SPRAY IS USED, FOG NOZZLES ARE PREFERABLE. Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT. ISOLATE FROM HEAT, SPARKS & OPEN FLAME. ================== Accidental Release Measures ================== Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. CONTAIN SPILL, ABSORB LIQUID W/CLAY, SAND & FLOOR ABSORBENT. PREVENT RUN-OFF TO SEWERS, STREAMS/OTHER BODIES OF WATER. ====================== Handling and Storage ====================== Handling and Storage Precautions:KEEP AWAY FROM HEAT, SPARKS & OPEN FLAME. DON'T TAKE INTERNALLY. AVOID PROLONGED CONTACT W/SKIN. Other Precautions:CONTAINERS SHOULD BE GROUNDED WHEN POURING. AVOID FREE FALL OF MORE THAN 2-3 INCHES WHEN POURING. ============= Exposure Controls/Personal Protection ============= Respiratory Protection:NIOSH/MSHA JOINTLY APPROVED AIR SUPPLIED RESPIRATOR IF TLV ARE EXCEEDED APPROVED MECHANICAL FILTER TO REMOVE SOLID AIRBORNE PARTICLES OF OVERSPRAY DURING SPRAY APPLICATION. Ventilation:PROVIDE SUFFICIENT MECHANICAL/LOCAL EXHAUST VENTILATION TO KEEPAIR Evaporation Rate & Reference:SLOWER THAN ETHER ================= Stability and Reactivity Data ================= Stability Indicator/Materials to Avoid:YES CONTACT W/STRONG OXIDIZING AGENTS Stability Condition to Avoid:ISOLATE FROM HEAT, OPEN FIRE & SPARKS Hazardous Decomposition Products:CO, POSSIBLE ACROLEIN & OXIDES OF NITROGEN ==================== Disposal Considerations ==================== Waste Disposal Methods:CONTAMINATED ABSORBENT MAY BE DEPOSITED IN LANDFILL IN ACCORDANCE W/LOCAL, STATE & FEDERAL REGULATIONS. Disclaimer (provided with this information by the compiling agencies): This information is formulated for use by elements of the Department of Defense. The United States of America in no manner whatsoever, expressly or implied, warrants this information to be accurate and disclaims all liability for its use. Any person utilizing this document should seek competent professional advice to verify and assume responsibility for the suitability of this information to their particular situation.