IPS CORPORATION -- WELD ON 705 FOR PVC PLASTIC PIPE -- 8040-00-573-1502 
=====================  Product Identification  =====================

Product ID:WELD ON 705 FOR PVC PLASTIC PIPE
MSDS Date:06/01/1990
FSC:8040
NIIN:00-573-1502
=== Responsible Party ===
Company Name:IPS CORPORATION
Address:17109 S. MAIN ST.
Box:379
City:GARDENA
State:CA
ZIP:90248
Country:US
Info Phone Num:213-321-6515
Emergency Phone Num:213-484-5151(CHEMTREC 800-424-9300)
Preparer's Name:GEORGE BLANCO
CAGE:IPSCO
=== Contractor Identification ===
Company Name:IPS CORPORATION
Address:17109 SOUTH MAIN STREET
Box:379
City:GARDENA
State:CA
ZIP:90248
Country:US
Phone:310-366-3300
CAGE:IPSCO

=============  Composition/Information on Ingredients  =============

Ingred Name:POLYVINYL CHLORIDE RESIN
CAS:9002-86-2
RTECS #:KV0350000
Fraction by Wt: 10-20%
Other REC Limits:NONE SPECIFIED

Ingred Name:TETRAHYDROFURAN  (SARA III)
CAS:109-99-9
RTECS #:LU5950000
Fraction by Wt: 30-45%
Other REC Limits:NONE SPECIFIED
OSHA PEL:200 PPM/250 STEL
ACGIH TLV:200 PPM/250STEL;9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:METHYL ETHYL KETONE (2-BUTANONE) (MEK)  (SARA III)
CAS:78-93-3
RTECS #:EL6475000
Fraction by Wt: 36%
Other REC Limits:NONE SPECIFIED
OSHA PEL:200 PPM/300 STEL
ACGIH TLV:200 PPM/300STEL 9192
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:CYCLOHEXANONE  (SARA III)
CAS:108-94-1
RTECS #:GW1050000
Fraction by Wt: 5-10%
Other REC Limits:NONE SPECIFIED
OSHA PEL:S, 50 PPM
ACGIH TLV:S, 25 PPM; 9293
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:CEMENT CNTNS 765 GRAMS VOC PER LITER AS MFR'D. MORE THAN
    60% OF VOC ACTS AS A REACTIVE DILUENT & REMAINS IN PIPE JOINT.
RTECS #:9999999VO
Other REC Limits:NONE SPECIFIED

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:NO
Health Hazards Acute and Chronic:INHALATION: SEVERE OVEREXPOSURE MAY
    RESULT IN NAUSEA, DIZZINESS, HEADACHE. CAN CAUSE DROWSINESS,
    IRRITATION OF EYES & NASAL PASSAGES. SKIN: IRRITANT. LIQUID CONTACT
    MAY REMOVE NATURAL SKIN OILS RESULT ING IN SKIN IRRITATION.
    DERMATITIS MAY OCCUR WITH PROLONGED CONTACT. SKIN ABSORPTION:
    PROLONGED OR WIDESPREAD EXPOSURE**
Effects of Overexposure:**MAY RESULT IN THE ABSORPTION OF HARMFUL
    AMOUNTS OF MATERIAL. EYE: OVEREXPOSURE MAY RESULT IN SEVERE EYE
    INJURY WITH CORNEAL OR CONJUCTIVAL INFLAMMATION ON CONTACT WITH THE
    LIQUID. VAPORS SLIGHTLY UN COMFORTABLE. INGESTION: MODERATELY
    TOXIC. MAY CAUSE NAUSEA, VOMITING, DIARRHEA. MAY CAUSE MENTAL
    SLUGGISHNESS.
Medical Cond Aggravated by Exposure:NONE CURRENTLY KNOWN.

=======================  First Aid Measures  =======================

First Aid:INHALE: REMOVE TO FRESH AIR. BREATHING STOPS, GIVE
    CPR-PREFERABLY MOUTH-TO-MOUTH. BREATHING DIFFICULT, GIVE OXYGEN.
    CALL DR. EYE: FLUSH EYES W/PLENTY OF WATER-15 MIN. CALL DR. SKIN:
    REMOVE CONTAMINATE D CLOTHING & SHOES. WASH SKIN W/PLENTY OF SOAP &
    WATER-15 MIN. IF IRRITATION DEVELOPS, GET MEDICAL AID. INGESTION:
    GIVE 1 OR 2 GLASSES WATER OR MILK. DO NOT INDUCE VOMIT. CALL DR OR
    POISON CNTRL CTR.

=====================  Fire Fighting Measures  =====================

Flash Point Method:TCC
Flash Point:6F,-14C
Lower Limits:1.8
Upper Limits:11.8
Extinguishing Media:ANSUL "PURPLE K", POTASSIUM BICARBONATE, DRY CHEM,
    CO2, NAT'L AER-O-FOAM UNIVERSAL ALCOHOL RESISTANT FOAM, WATER
    SPRAY.
Fire Fighting Procedures:EVACUATE ENCLOSED AREAS, STAY UPWIND. USE
    SCBA, POS PRESS HOSE MASKS, AIRLINE MASKS IN CONFINED SPACES. USE
    WTR SPRAY TO COOL CNTNRS, FLUSH SPILL FROM IGNITE**
Unusual Fire/Explosion Hazard:FIRE HAZARD BECAUSE OF LOW FLASH POINT
    AND HIGH VOLATILITY. VAPORS ARE HEAVIER THAN AIR AND MAY TRAVEL TO
    SOURCE OF IGNITION.     **SOURCE & TO DISPERSE VAPORS.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE IGNITE SOURCES. AVOID BREATHING VAPORS.
    KEEP LIQUID OUT OF EYES. FLUSH W/LARGE AMOUNT WATER. CONTAIN LIQUID
    W/SAND/EARTH. ABSORB W/SAND OR NONFLAMMABLE ABSORB MAT'L & TRANSFER
    TO STEEL DRUMS FO R RECOVERY/DISPOSAL. PREVENT FROM ENTERING
    DRAINS.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN SHADE BETWEEN 40F-110F. KEEP
    FROM IGNITE SOURCES. AVOID PROLONGED BREATHING OF VAPORS. USE
    W/ADEQUATE VENT. AVOID EYE, SKIN,CLOTHING CONTACT.
Other Precautions:TRAIN EMPLOYEES ON ALL SPECIAL HANDLING PROCEDURES
    BEFORE THEY WORK W/PRODUCT. FOLLOW ALL PRECAUTIONARY INFORMATION
    GIVEN ON CONTAINER LABEL, PRODUCT BULLETINS & OUR SOLVENT CEMENTING
    LITERATURE. ELEC TRONICALLY GROUND ALL HANDLING EQUIP.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IN SITUATIONS WHERE VAPOR CONCENTRATIONS EXCEED
    THE RECOMMENDED EXPOSURE LIMITS, A NIOSH-APPROVED ORGANIC VAPOR
    CARTRIDGE RESPIRATOR WITH FULL FACE-PIECE IS RECOMMENDED. USE ONLY
    SCBA FOR EMERGENCIES.
Ventilation:EXPLOSION-PROOF GENERAL MECHANICAL VENT OR LOCAL EXHAUST IS
    RECOMMENDED TO MAINTAIN VAPOR CONC BELOW EXPOSURE LIMITS.
Protective Gloves:PVA COATED.
Eye Protection:SPLASHPROOF CHEMICAL GOGGLES.
Other Protective Equipment:IMPERVIOUS APRON AND A SOURCE OF RUNNING
    WATER TO FLUSH OR WASH THE EYES AND SKIN IN CASE OF CONTACT.
Supplemental Safety and Health

==================  Physical/Chemical Properties  ==================

HCC:F3
Boiling Pt:B.P. Text:151F,66C
Vapor Pres:143 MM HG
Vapor Density:2.49
Spec Gravity:0.920 +-0.020
Evaporation Rate & Reference:5-8 (BU AC=1)
Solubility in Water:COMPLETE*
Appearance and Odor:CLEAR OR GRAY SYRUPY LIQUID, ETHEREAL ODOR.
Percent Volatiles by Volume:85-90

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
CAUSTICS, AMMONIA, INORGANIC ACIDS, CHLORINATED COMPOUNDS, STRONG
    OXIDIZERS AND ISOCYNATES.
Stability Condition to Avoid:KEEP AWAY FROM HEAT, SPARKS, OPEN FLAME
    AND OTHER SOURCES OF IGNITION.
Hazardous Decomposition Products:WHEN FORCED TO BURN, THIS PRODUCT
    GIVES OUT CARBON MONOXIDE, CARBON DIOXIDE,	HYDROGEN CHLORIDE AND
    SMOKE.
Conditions to Avoid Polymerization:KEEP AWAY FROM HEAT, SPARKS, OPEN
    FLAME AND OTHER SOURCES OF IGNITION.	     *RESIN PORTION
    PRECIPITATES IN WATER.

====================  Disposal Considerations  ====================

Waste Disposal Methods:FOLLOW LOCAL, STATE AND FEDERAL REGULATIONS.
    CONSULT DISPOSAL EXPERT. CAN BE DISPOSED OF BY INCINERATION.
    EXCESSIVE QUANTITIES SHOULD NOT BE PERMITTED TO ENTER DRAINS. EMPTY
    CONTAINERS SHOULD BE AIR D RIED BEFORE DISPOSING. HAZARDOUS WASTE
    CODE: 214.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.