ZYNOLYTE PRODUCTS CO -- 0530 APPLIANCE WHITE, AEROSOL SPRAY PAINT -- 8010-00N027607
=====================  Product Identification  =====================

Product ID:0530 APPLIANCE WHITE, AEROSOL SPRAY PAINT
MSDS Date:03/23/1988
FSC:8010
NIIN:00N027607
=== Responsible Party ===
Company Name:ZYNOLYTE PRODUCTS CO
Address:2320 E DOMINGUEZ ST
City:CARSON
State:CA
ZIP:90749
Country:US
Info Phone Num:310-513-0700
Emergency Phone Num:310-513-0700
CAGE:25461
=== Contractor Identification ===
Company Name:ZYNOLYTE PRODUCTS CO
Address:2320 E DOMINGUEZ ST
Box:6244
City:CARSON
State:CA
ZIP:90749
Country:US
Phone:310-513-0700
CAGE:25461

=============  Composition/Information on Ingredients  =============

Ingred Name:SOLVENT NAPHTHA (PETROLEUM), LIGHT AROMATIC. VP: 10 @ 20C.
CAS:64742-95-6
RTECS #:WF3400000
OSHA PEL:25 PPM (MFR)
ACGIH TLV:25 PPM (MFR)

Ingred Name:HEAVY AROMATIC NAPHTHA. VP: 10 @ 20C.
CAS:64742-94-5
RTECS #:WF3100000
Other REC Limits:100 PPM (MFR)

Ingred Name:MINERAL SPIRITS; (MEDIUM MINERAL SPIRITS). VP: 2 @ 20C.
CAS:64742-88-7
Other REC Limits:100 PPM (MFR)

Ingred Name:VM & P NAPHTHA. VP: 26 @ 20C.
CAS:64742-89-8
OSHA PEL:300 PPM, 400 STEL
ACGIH TLV:300 PPM

Ingred Name:METHANE, DICHLORO-; (METHYLENE CHLORIDE). VP: 400 @ 20C.
CAS:75-09-2
RTECS #:PA8050000
OSHA PEL:500 PPM, C
ACGIH TLV:50 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:POLYMER; (NON-HAZARDOUS POLYMER)

Ingred Name:TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS:13463-67-7
RTECS #:XR2275000
OSHA PEL:15 MG/M3 TDUST
ACGIH TLV:10 MG/M3 TDUST; 9293

Ingred Name:COBALT OCTOATE 6%
OSHA PEL:0.05 MG/M3 TDUST(CO)
ACGIH TLV:0.05 MG/M3 TDUST(CO)

Ingred Name:PROPANE
CAS:74-98-6
RTECS #:TX2275000
OSHA PEL:1000 PPM
ACGIH TLV:SIMPLE ASPHYXIANT

Ingred Name:HYDROTREATED HEAVY NAPHTHA
CAS:64742-48-9
Other REC Limits:100 PPM (MFR)

Ingred Name:PROPANE, 2-METHYL-; (ISOBUTANE)
CAS:75-28-5
RTECS #:TZ4300000

Ingred Name:TOLUENE  (SARA III). VP: 36.7 @ 20C.
CAS:108-88-3
RTECS #:XS5250000
OSHA PEL:200 PPM/150 STEL
ACGIH TLV:50 PPM; 9293
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:XYLENE. VP: 25.0 @ 20C.
CAS:1330-20-7
RTECS #:ZE2100000
OSHA PEL:100 PPM;150 PPM STEL
ACGIH TLV:100 PPM;150 PPM STEL
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:YES    IARC:YES	  OSHA:NO
Health Hazards Acute and Chronic:INGEST:GI DISTRESS. INHAL: OVEREXP MAY
    CAUSE NOSE/THROAT IRRIT. MAY CAUSE CNS EFTS SUCH AS DIZZ, HDCH,
    NAUS, STAG GAIT, CONFUSION & UNCON. RPTS HAVE ASSOC RPTD/PRLNGD
    OVEREXP TO SOLV W/PERM BRAIN & NE RV SYS DMG. EYE: MAY CAUSE EYE
    IRRIT/BURNING OF EYES. SKIN: RPTD/PRLNGD LIQ CONT MAY CAUSE SKIN
    IRRIT/ (EFTS OF OVEREXP)
Explanation of Carcinogenicity:METHYLENE CHLORIDE: GROUP 2 (NTP), 2B
    (IARC). NICKEL: GROUP 2 (NTP), 2B (IARC).
Effects of Overexposure:HLTH HAZ: BURNING OF EYES. SKIN: RPTD/PRLNGD
    LIQ CONT MAY CAUSE SKIN IRRIT W/DISCOMFORT/DERM. CHLOROCARBON MATLS
    HAVE PRDCD SENSIT OF MYOCARDIUM TO EPINEPHRINE IN LAB ANIMALS &
    COULD HAVE SIMILAR EFFE CT IN HUMANS. ADRENOMIMETICS (E.G.,
    EPINEPHRINE) MAY BE CONTRAINDICATED EXCEPT FOR LIFE-SUSTAINING USES
    IN (SUPP DATA)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

First Aid:INGESTION: CALL PHYSICIAN IMMED AND HAVE NAMES OF INGREDIENTS
    AVAILABLE. DO NOT INDUCE VOMITING. INHALATION: REMOVE TO FRESH AIR.
    IF NOT BREATHING, GIVE ARTF RESP, PREFERABLY MOUTH TO MOUTH. IF
    BREATH ING DFCLTY PERSISTS, OR OCCURS LATER, CONSULT PHYSICIAN.
    EYE: IMMEDIATELY FLUSH WITH PLENTY OF WATER FOR AT LEAST 15
    MINUTES; CALL PHYSICIAN. SKIN: WASH W/SOAP & H*2O. IF IRRIT OCCURS,
    CONT PHYSICIAN.

=====================  Fire Fighting Measures  =====================

Flash Point Method:COC
Flash Point:<20F,<-7C
Extinguishing Media:FOAM, CARBON DIOXIDE, DRY CHEMICAL.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED PRESS DEMAND SCBA &
    FULL PROT EQUIP . H*2O MAY BE INEFT. H*2O FROM FOG NOZ MAY BE USED
    TO COOL CLSD CNTNRS TO PVNT PRESS BUILDUP.
Unusual Fire/Explosion Hazard:CONTENTS UNDER PRESS.KEEP AT ROOM TEMP AS
    EXPOS TO SUNLIGHT/OTHER HEAT MAY CAUSE CANS TO BURST, PROPELLING
    CONTENTS ACROSS AREA. THERM DECOMP PRODS MAY (SUPDAT)

==================  Accidental Release Measures  ==================

Spill Release Procedures:VENTILATE AREA. REMOVE SOURCES OF IGNITION.
    PREVENT SKIN CONTACT AND BREATHING OF VAPOR. CONFINE AND REMOVE
    WITH INERT ABSORBANT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:OBSERVE LABEL PRECAUTIONS. KEEP AWAY
    FROM HEAT, SPARKS AND FLAME. DO NOT STORE ABOVE 120F. DO NOT EXPOSE
    TO DIRECT SUNLIGHT TO AVOID BURSTING.
Other Precautions:DO NOT SAND,FLAME CUT,BRAZE/WELD DRY COATING W/OUT
    NIOSH/MSHA APPRVD RESP/APPROP VENT. DO NOT PUNCTURE. DO NOT SPRAY
    NEAR FIRE/OPEN FLAME. NO SMOKING IN AREA OF USE. DO NOT USE IN GEN
    VICINITY OF ARC  WELDING, OPEN FLAMES/HOT SURFS. (SUPDAT)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:WEAR AN APPROPRIATE NIOSH/MSHA APPROVED PROPERLY
    FITTED RESPIRATOR DURING AND AFTER APPLICATION UNLESS AIR
    MONITORING DEMONSTRATES VAPOR/MIST LEVELS ARE BELOW APPLICABLE
    LIMITS.
Ventilation:PROVIDE SUFFICIENT VENTILATION IN VOLUME AND PATTERN TO
    KEEP CONTAMINANTS BELOW APPLICABLE OSHA REQUIREMENTS.
Protective Gloves:NEOPRENE GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:COVERALLS. PROTECTIVE CREAMS MAY BE USED FOR
    EASE OF CLEAN-UP, NOT FOR PROTECTION.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING AND BEFORE
    EATING AND SMOKING.
Supplemental Safety and Health
SOL IN H*2O: APPRECIABLE, DEPENDING ON COLOR.EXPLO HAZ: INCL HCL &
    PHOSGENE . EFTS OF OVEREXP: HUMANS ACUTELY/CHRONICALLY EXPOS TO
    CHLOROCARBONS . FOR MORE EXACTING INFO CONCERNING INDIV I NGRED
    HLTH HAZ CONT NEHC . OTHER PREC: HEAT AND/OR UV RADIATION MAY CAUSE
    FORMATION OF HCL AND/OR PHOSGENE .

==================  Physical/Chemical Properties  ==================

HCC:V3
Boiling Pt:B.P. Text:<0F,<-18C
Vapor Pres:SEE INGRED
Vapor Density:HVR/AIR
Spec Gravity:0.745 
Evaporation Rate & Reference:FASTER THAN ETHER
Solubility in Water:MODERATE-(SUPP DATA)
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:92

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE REASONABLY FORSEEABLE.
Stability Condition to Avoid:DO NOT STORE ABOVE 120F.
Hazardous Decomposition Products:CO, CO*2, SMOKE, OXIDES OF HEAVY
    METALS REPORTED IN INGRED SECTION. HCL, PHOSGENE .

====================  Disposal Considerations  ====================

Waste Disposal Methods:DO NOT ALLOW MATERIAL TO CONTAMINATE GROUND
    WATER SYSTEMS. INCINERATE ABSORBED MATERIAL IN ACCORDANCE WITH
    FEDERAL, STATE AND LOCAL REQUIREMENTS. DO NOT INCINERATE IN CLOSED
    CONTAINERS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.